How to Disable Periodic Filter and Service Discovery in Neverfail Heartbeat V5.3.0 and Later

Follow

Summary

This Knowledgebase article provides information about how to configure or disable periodic filter and service discovery in Neverfail Heartbeat V5.3.0 and later.


More Information

Neverfail Heartbeat V5.3.0 is configured, by default, to run tasks periodically, which will determine the current set of file filters, the current set of protected services, and the current state of protected services (running or stopped).

To view/configure periodic filter discovery tasks, follow the steps below:

  1. Navigate to Application -> Tasks .
  2. Under the 'Periodic' node, select the desired task.
  3. Click on the Edit button (alternatively, right-click on the desired task and select Edit ).
  4. Change the 'Interval' to the desired frequency (measured in seconds).
    Note: If the 'Interval' is set to "0", the task will run only once, immediately.
  5. Click on the OK button.

Note: To disable the task, clear the 'Enabled' check box and click on OK .


Applies To

Neverfail Heartbeat V5.3.0 and Later


Related Information

None

KBID-1410

0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.