Prerequisites for Installing the Neverfail Business Application Plug-in

Follow

Summary

This Knowledgebase article provides the prerequisites for installing the Neverfail for Business Application Plug-in.


More Information

The Business Application Plug-in is installed post Neverfail Heartbeat installation and requires the following be completed before it is installed"

  • If you are not using the same host name for all servers in a Cluster, you must configure Alternate IP addresses on all servers in the Secondary sites.
  • Configure persistent static routes for the Neverfail Channel between the servers within a Business Application Group site as explained below:
    • Configure persistent static routes between all of the Primary servers within the Business Application Group at the Primary HA site.
    • Configure persistent static routes between all of the Secondary servers within the Business Application Group at the Primary HA site.
    • Configure persistent static routes between all of the servers within the Business Application Group at the DR site.

Note: Add persistent routes with a lower metric to allow them to be attempted first.

Once these tasks have been completed, you may then install the Business Application Plug-in via the Neverfail Heartbeat Management Client.


Applies To

Neverfail Heartbeat v6.6 and Later


More Information

None

KBID-2394

0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.