How to add/replace a server to an Engine pair/trio from EMS using manual cloning
Summary
This Knowledgebase article provides the step-by-step procedure for replacing a server from EMS.
More Information
Initial Assumptions
- The Primary Active server will be cloned.
- The Secondary/Tertiary Passive server will be replaced by the new clone of Primary active server.
Procedure
1. Make sure the Primary Active server is added into the EMS (Engine Management Server). If Primary is not added into EMS then use the 'Manage\Add Protected Server' option to add it.
2. For replacing a Secondary server use the 'Deploy\Add a stand-by server for high availability' option. For replacing a Tertiary use the 'Deploy\Add a stand-by server for disaster recovery' option.
3. In the new window choose the 'Select manual cloning' option and fill in the required IPs for the Channel connection.
4. Wait for the Primary server reconfiguration until EMS shows the message 'Primary Server ready to be cloned...'
5. Clone the Primary server manually.
6. Once the cloning of the Primary is finished click the Cancel button in the 'Install Status' field of EMS.
7. Power-up the newly created machine resulted from cloning. This is already pre-configured to run as a Secondary or Tertiary within your Neverfail pair/trio depending on the option you chose at step 2.
Related Articles
How To Clone A Primary Server With Windows Backup (Wbadmin) For Deploying A Secondary Server By Using Neverfail EMS Console
Summary This KB article describes how to use Windows Server Backup (aka, wbadmin) in order to clone the Primary server for completing the deployment of Engine on a Secondary or even a Tertiary server. Since Engine is already installed on the Primary ...Using the Neverfail Continuity Engine Management Service
Summary This Knowledgebase article provides an introduction to the Neverfail Continuity Engine Management Service. More Information Using the Engine Management Service User Interface The Engine Management Service is the primary tool used for ...Neverfail Continuity Engine Cloning Technology Options
Summary This Knowledgebase article provides information about Neverfail Continuity Engine cloning technology options. More Information Cloning Technology Options Cloning the Primary server to create a nearly identical Secondary or Tertiary server ...How to Test a Neverfail Continuity Engine Pair Deployment Before Production Using AVT
Summary This Knowledgebase article describes the procedure used to perform installation verification testing of a Neverfail Continuity Engine pair. Please see Neverfail Continuity Engine v9.0 Installation Guide for installation verification testing ...Semi-Automatic Deployment of Stand-by Servers Leveraging Manual Cloning
Summary This Knowledgebase article provides the basic procedure used to semi-automatically deploy a stand-by server using a manual cloning technique. More Information Procedure In Neverfail Engine Management Server (EMS) navigate to Management > ...